Cub Cadet 769-11722F, Руководство пользователя

Страница: 21 / 46

21
Servicing
EN
Servicing
WARNING!
Risk of injuries or material damage
¾
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾
Remove the ignition key and the spark-
plug connectors.
¾
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾
Never reach into the rotating cutter blades.
¾
Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾
Only have the cutter blades replaced or re-
sharpened by a specialist service centre.
¾
Clean the device and all add-on and
accessory parts after every instance of use.
Cleaning the device
Attention!
¾
Do not use high-pressure cleaners for cleaning
the device.
Î
Park the device on firm and level ground.
Î
Switch the parking brake on.
Î
Clean the device with a scrubbing brush, hand
brush or a cloth.
Cleaning the cutter deck
DANGER!
Sharp, moving cutting tools
Â
Risk of injury
¾
Wear protective gloves.
¾
Clean the cutting tools carefully.
¾
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
Attention!
Fuel may run into the combustion chamber.
Â
Damage to engine
¾
The device must not be tilted to an angle greater
than 30°.
Î
Bring the cutter deck to the top position.
Î
Clean the cutting chamber with a scrubbing brush,
hand brush or a cloth.
Cutter deck with cleaning nozzle
(optional)
W
Cleaning
Î
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
pling to attach a water hose.
Î
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
minutes.
Î
Switch the engine and cutter deck off.
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Î
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
deck to run for a few minutes.
Î
Switch the engine and cutter deck off.
Starting the device
Î
Observe the servicing instructions in the engine
manual.
Î
At the end of the season, have the device in-
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Hand over used batteries to your dealer or to
a waste management company. Remove the
battery before scrapping the device.
Using jump leads
DANGER!
Risk of explosion / short-circuit
¾
Never bypass a defective or frozen
battery with jump leads.
¾
Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Î
Attach the red jump lead to the positive terminal
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Î
Connect the black jump lead first to the negative
terminal (–) of the donor battery.
Î
Connect the other clip to the frame of the lawn
tractor’s engine block as far from the battery as
possible.