CTR Logika, Руководство по эксплуатации и обслуживанию

Страница: 7 / 17

J J
L
6/16
Logika - use and maintenance guide page
In case of power-down due to a shortage of feeding, wait for approx. 10 seconds
before restarting the machine to allow sufficient time for the electronic components
to be correctly reset.
Use the wheels on the
bottom of the machine to
push it by hand.
Always use the four wheels
to move the machine. Avoid
to tilt it even for short move.
To lift the machine at a
distance, use a fork lift
suitable to take the machine
weight (see the section on
technical characteristics)
inserting the forks as
illustrated in the figure
above.
The electrical connections to the machine should be carried out following the instructions
supplied by CTR s.p.a. which, in any case, is not responsible for connections. Check that
the connection point to the main supply is equipped with the prescribed safety devices
in accordance with the relevant codes in force (differential circuit-breaker mechanism and
earthing (grounding system). We advise you to follow the instructions below to correctly
connect up the electrical circuit.
• In the workshop it is necessary to connect the machine up to the mains using the
apposite plug that comes with the machine, checking that the supply voltage
corresponds to the value on the machine plate.
• If you are using an extension cable, check that the cable core section is proportioned
to the length of the cable and that it is positioned where it cannot be damaged in any
way (avoid areas where it can be walked on or damp surfaces).
• In the event of a component breaking, please only contact our after-sales technical
service.
5. Handling and transport
4. Electricity supply
Switch off the machine and disconnect it from the electric system.
!
Please keep original packaging (pallet, box and polystyrene) for possible future
shipments.