CTD Iguane 120-30, Руководство пользователя

Страница: 13 / 31

13
3 – FOAM CONCENTRATE TANK DOSING :

Connect a lance on the pre-mix output.

The flow and pressure are displayed [
1
] and [
5
].

Start the engine of the GECKO.

Select the type of fire using the concentration selection keys T7 to T8 .

Système prime automatically (min. 2s).

The concentration (%) and the injection pressure appears on the screen [ 2 ] and [ 4 ].

Dosage begins if the flow rate is greather than 100L/min.

The box displays « Water flow is too weak » if the ratio of water flow / product flow is
lower than the minimum performance of dosing system

The box displays « Water flow is too strong » if the flow ratio of water / product flow is
higher than the minimum performance of dosing system.

At any time, the system beeps, a fault is detected and displayed :
- « Injection fault»: The injection pressure has remained under the water pressure
during more than 15 seconds. Try again. If the problem persists, contact our after
sales service.
- « Additive presence fault »: The priming was not done correctly. Try again. If the
problem persists, contact our after sales service.

To stop the dosage, press the key «
STOP
»
T1 .

Flushing is done automatically.

At any moment it is possible to reselect an intervention by simply pressing the desired
type of fire.
7 - Foam
concentrate
tank level
2
4 5
1
T3 T4 T7 T8 T5 T6
Intervention procedure