CTD D45AX, Инструкция по эксплуатации и руководство по техническому обслуживанию, Страница: 4 / 26

Blade Installation :
Before setting blades on spindle, always shut off or disconnect air supply. With motor OFF and power
disconnected, remove blade guard by removing wing nuts on top of main blade guard. Also remove bolts located
at the front and sides of the blade guard. Remove main guard completely, by lifting off machine, exposing Arm
Assembly.
1. Remove Spindle Nut, P/N 15B1P36 or 37 and Outer Flange, P/N 150M13X. If necessary, hold blade in
hand with rag or lower blade into a piece of wood. Push down with a 15/16” wrench.
2. Place blade on spindle with tips pointing down. Make sure Slinger (inner flange P/N 150M14X) and blade
surface are clean before putting blade on spindle. This is a critical surface and is ground within.0005
flatness. Any debris or dust will wear this surface. Wipe both surfaces (blade and slinger) with a clean rag.
A. The blade must
ALWAYS rotate to the rear of the machine on the underside of the blade
(see Diagram “D” on page No. 8).
Always check rotation before cutting a piece of material.
3. Replace Outer Flange, P/N 150M13X and nut
as before and tighten (refer to Diagram “B”).
Pull up with wrench. Do not over-tighten.
snugging the blade is all that is necessary.
If blades were purchased from CTD, your machine has
been set with your blades. If not, blade diameters may
vary. Check to see if the blades you are using conform
to Diagram “C”. If repositioning is necessary, follow
instructions below.
1. Position the arms so that the centerline of the
spindles are 2” above the table (see Diagram “D”).
A 1-1/2” thick spacer placed between the spindle nut flat and the table will bring the centerline up to 2”. It
is at this
position that the two blades are the closest together .
2. Set blades as shown in Diagram “C” about 1/8” apart.
A. Loosen three hold down bolts on pivot bracket and move the entire arm and pivot assembly in or out of
its original position as needed in the keyway (see Diagram “E”).
B. Tighten three hold down bolts after positioning heads.
3. Use this method of setting blades ONLY . If blades are set at table level, they will contact each other on the
upstroke. This can cause severe damage to the blades.
Diagram “B”
Diagram “C”
Diagram “E”
-4-