CTD D45AX, Инструкция по эксплуатации и руководство по техническому обслуживанию, Страница: 3 / 26

-3-
Installation and Set Up:
CTD 12”, and 14” Models D45AX Automatic & D45FX Foot Cut Off Saws:
The CTD saw you have purchased is designed to cut wood, aluminum, and plastic, with of course, the proper
blade and conditions. For the material you are cutting, please refer to the cutting instructions for
each material type. The D45AX uses a NEMA 56 Frame 1-1/2 H.P., 3450 RPM, 60 HZ TEFC motor. CTD
uses a speed-up drive so that the blade will run at approximately 9500 SFPM on a 10” blade, and 11,400 SFPM
on a 12” blade. The D45AX and D45FX are exactly the same machine with the exception of the Air Pneumatic
System. All instructions will pertain to
both
machines unless specifically excluded.
IMPORTANT
: Before operating saw, please be sure to read the “SAFETY INSTRUCTIONS TO THE OP-
ERATOR” (on Page No. 11).
Note:
The floor stand must be shimmed, leveled and bolted to the floor or framed in to eliminate vibration.
Use holes provided in bottom of floor stand. All machines have been completely assembled at the factory,
then disassembled for shipment.
Space Requirements:
Assembly of Tables to Floor Stand:
1. Assemble leg to table with 3/8-16 bolts and nuts provided. Turn table upside down and attach leg to
table with leg rising vertically.
Note
: The hole in the table (when mounted properly) should be toward
the front of the table and far away from the blade to attach Fence Support Angle, P/N 15F82
(see Diagram “A”). If you have purchased a Vision Gage Assembly, be careful to protect lined measuring
gage.
2. Attach Table, P/N BF17 to machine floor stand on Angle Bracket, P/N BF05A. Use 3/8-16 bolts and
nuts provided on angle bracket.
Diagram “A”