CTD D45AX, Инструкция по эксплуатации и руководство по техническому обслуживанию, Страница: 14 / 26

Cutting Aluminum:
As with cutting any material, it is important that aluminum be clamped properly. Precision blades are required
for accurate cutting. CTD suggests and uses a Triple Chip Grind on all its non-ferrous Carbide Blades. When
cutting aluminum, or other non-ferrous materials, it is essential that the blades be lubricated with a Spray Mist
System or other blade lubricating system for the finest finish. See SAWBLADE LUBRICATION SYSTEM
below for more details.
Combination Blades:
Any combination blade is basically an aluminum cutting blade. Significant blade life in between sharpenings
will be lost if a blade is used for cutting both aluminum and wood. The amount of production for either wood
or aluminum should be the determining factor in the assessment of the particular blade type to be used. Please
consult factory.
Sawblade Lubrication System:
The Sawblade Lubrication System is used when cutting aluminum or other non-ferrous material . This system
normally uses a Water Soluble Oil mixture of
10 parts water to one part oil.
The system operates by syphoning
the lubrication up the line to the spray nozzle. Any air leak will cause inconsistent fluid flow to the spray nozzle.
BE SURE
your fluid is free from chips and other debris. A fluid container supplied with the machine contains a
One-Way Check Valve, Part No. B3P96 at the end of the clear fluid line. This check valve helps to hold the
lubrication in the line. However, after a couple of minutes the lubrication or oil will back-flow into the container.
Priming of the system may be necessary if the machine has been standing without use. The system may be shut off
by closing the toggle valve next to the vacuum pump. The fluid must be clean or the vaccum pump will clog.
CTD Bio Lubrication System:
The CTD biodegradable lubrication system operates by pulse spraying a minute amount of biodegrad-
able lubricant directly on to the saw tooth of the blade in time-measured increments. The majority of the
lubricant then dissipates with the heat of the cutting action. Chips coming off the blade are hot and dry, and are
more easily collected (see specific instructions included with system).
-14-