CTC Union EcoLogic L, Руководство по установке и обслуживанию

Страница: 80 / 164

80 CTC EcoLogic M/L
4.10.2.2 Remote control functions
The "Installer/Define/Remote Control" menu defines
Inputs for current remote control functions:
• terminal blocks K22, K23, K24, K25.
• wireless accessories in the SmartControl series
(Channel 1A, 1B, 2A, 2B, 3A, 3B and so on up to
7B).
• BMS digital input 0-7. Specify a value 0-255. The
value must be set again within half an hour for the
setting to persist.
Ethernet (Modbus TCP/Off)
For information about Modbus TCP Port settings, refer
to the "Communication" section in the "Installer/Settings"
chapter.
Night reduction (HC1-*)
(Off/ K22-K25 /Channel 1A-7B / BMS DI0-7)
The "Night Reduction" function can be used to, for
example, lower the indoor temperature during the night
or during working hours.
In the "Installer / Define/Remote Control" menu:
• specify an "Input" for the remote control function.
In the "Installer / Define/Heating Circuit" menu:
• configure the normal mode for the external control
signal (Normally Open (NO)/Normally Closed (NC)).
The weekly program can be set in the "Room
Temperature" menu.
For more information, refer to the "Night Reduction
Temperature" section in the "Room Temperature"
chapter.
Heating mode, ext (HC1-*)
(Off/ K22-K25 /Channel 1A-7B / BMS DI0-7)
Switching between heating season and summer season
can take place at a specific outdoor temperature (Auto)
or heating can be either always "On" or "Off".
In the "Installer / Define/Remote Control" menu:
• specify an "Input" for the remote control function.
In the "Installer / Define/Heating Circuit" menu:
• configure the normal mode for the external control
signal (Normally Open (NO)/Normally Closed (NC)).
In the "Installer /Settings/Heating Circuit" menu:
• set "Remote Control Mode" ("On", "Off" or "Auto")
in the "Heating mode, ext." row.
Access function scheduling from the "Heat mode,
schedule" row.
For more information, refer to the "Heating Circuit"
section in the "Installer/Settings" chapter.
Also refer to the "Your home’s heating settings" chapter.
*The number of possible heating circuits or heat pumps
that can be connected to the system varies depending
on the control system.
Menu: "Installer/Settings/Heating Circuit".
The remote control mode for the heating circuit is set on menu
bar "Heating mode, ext".
Access the weekly program from the menu bar "Heating mode,
schedule".
Part of the "Installer/Define/Remote Control" menu.
"Input" and "Weekly Program" are defined here.