CST rl25h, Руководство по эксплуатации

Страница: 30 / 80

-30-
W h i l e h o l d i n g t h e auto level button,
press and release the power button.
Release the auto level button.
The laser will indicate calibration mode by
alternating flashing the manual grade
(green LED) and ADS (green LED) at
rate of 2x per sec for 5 seconds.
Next, LEDs will illuminate solid to indicate axis
under calibration:
X axis
Manual grade green LED, on.
ADS green LED, off.
Y axis
Manual grade green LED, off.
ADS green LED, on.
Z axis
Must physically be in vertical application to
enter Z axis calibration.
Manual green LED, on.
ADS green LED, on.
Power LED will indicate level status:
solid: level
blinking: leveling
Up/Down arrows cause adjustment. Up
causes “+” adjustment in axis under
calibration
Auto level button switches axes in the horizontal
application. In Vertical application, it is not
possible to switch axes.
N e w c a l i b r a t i o n n u m b e r s a r e s a v e d
automatically
Calibration
Store and transport the
tool only in the supplied
protective case.
Keep the tool clean at all times.
Do not immerse the tool into water or
other fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents
or solvents.
Regularly clean the surfaces at the exit
opening of the laser in particular, and
pay attention to any fluff of fibers.
If the tool should fail despite the care
taken in manufacturing and testing
procedures, repair should be carried
out by an authorized after-sales service
center for Bosch power tools.
In all correspondence and spare parts
orders, please always include the
10-digit article number given on the
type plate of the tool.
In case of repairs, send in the tool
packed in its protective case.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries
instead of disposing of waste.
The unit, accessories, packaging
& used batteries should be sorted for
environmentally friendly recycling in
accordance with the latest regulations.
Maintenance and Service
!
WARNING