CST rl25h, Руководство по эксплуатации

Страница: 18 / 80

-18-
Remote control
Safety Notes
Read and observe all instructions.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Have the remote control repaired
only through a qualified
repair person and only
using identical replacement
parts. This will ensure
that the functionality of the remote control is
maintained. Do not operate the remote control
in explosive atmospheres, such as in the
presence of flammable liquids, gases or dusts.
Sparks can be created in the remote control
which may ignite the dust or fumes.
Read and strictly observe the safety warnings in
the operating instructions of the rotational laser.
Product Description and Specifications
Intended Use
The remote control is intended for controlling
CST/berger rotational laser levels with infra-red
receivers, in indoor and outdoor use.
Product Features
The numbering of the product features refers
to the illustration of the remote control on the
graphics page. (see page 17)
1. Hibernation mode button
2. Operation indicator
3. Sweep mode button
4. Right direction button
5. Button for “rotation in clockwise direction”
6. Lower direction button
7. Button for “rotation in counter clockwise
direction”
8. Left direction button
9. Button for rotational operation and selection
of the rotation speed
10. Button for single-axis slope operation or full
auto-leveling
11. Upper direction button
12. Battery lid
13. Latch of battery lid
14. Outlet opening for infra-red beam
The accessories illustrated or described are not
included as standard delivery.
Technical Data
Remote Control RM7
Article Number F034K69014
Working Range
1
100-ft
Operating Temperature +14ºF to 122ºF (-10ºC to +50ºC)
Storage Temperature -4ºF to 158ºF (-20ºC to +70ºC)
Batteries 2 x AA1.5v Alkaline
Weight 3.8 oz
1) The working range can be decreased by unfavourable
environmental conditions (e.g. direct sun irradiation).
Please observe the article number on the type plate of your remote
control. The trade names of individual remote controls may vary. For
clear identification of your remote control, see the serial number 13
on the type plate.
Assembly
Inserting/Replacing the Battery
Using alkaline batteries is recommended for
operation of the remote control. To open the
battery lid 12 , pull on the latch 13 and remove
the battery lid. Insert the batteries. When
inserting, pay attention to the correct polarity
according to the representation on the inside of
the battery compartment.
The batteries must be replaced when operation
indicator 2 no longer lights up after pressing any
button on the remote control.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the batteries from the remote control
when not using it for longer periods. When
storing for longer periods, the batteries can
corrode and discharge themselves.
Operation
Initial Operation
Protect the remote control against moisture and
direct sunlight.
Do not subject the remote control to extreme
temperatures or variations in temperature.
As an example, do not leave it in vehicles for
longer periods. In case of large variations in
temperature, allow the remote control to adjust
to the ambient temperature before putting it into
operation.
The remote control remains ready for operation
as long as batteries with sufficient voltage are
inserted.
Set up the rotational laser in such a manner that
the signals of the remote control directly reach
one of the receiption lenses on
the rotational laser (for this, see the operating
instructions of the rotational laser). When
the remote control cannot be pointed directly
against a receiption lens, the working range is
reduced. By reflecting the signal (e.g. against
walls), the working range can be improved,
even for indirect signals. After pressing a button