VCC-HD3 Rev. 905-0051-Z0
©2016 CIS Corporation. All rights reserved.
17
Others in 100s
Command
No.
Set Value
Initial Value
How to set the command.
And other information.
Camera
Setting
Store
100
0
～
3
Initial is 0
4 kinds of camera settings can be
stored.
The stored values cannot be saved
until SAVE command is executed.
The stored data and set values will
not be initialized by executing INIT
command.
Camera
Setting
Load
101
0
～
3
Initial is 0
To reflect the stored setting values
set by Camera
Setting
Store,
to the camera.
The set value will not be initialized
by executing INIT command.
*When Camera
Setting
Store is
executed, the setting values
forcibly become the one set by
Camera Setting Store.
LTC OFF/ON
103
0: OFF
0
To set LTC signals OFF/ON.
1: ON
LTC Reset
104
1: Reset
(Write Only)
To reset the internal free-running
timer of LTC.
No Command Numbers
Command
No.
Set Value
Initial Value
How to set the command.
And other information.
SAVE None
None
None
To save camera settings.
SAVE with capital letters.
*As to pixel defects correction, only
one table can be saved.
INIT None
None
None
To initialize the camera settings.
INIT with capital letters.
GVI None
1: Microcomputer’s version
2: FPGA’s version
None
To acquire the firmware’s version.
The letter strings such as 0.1 shall be
responded.
SDDW None
512
0
To start detection of pixel defects
Please refer to the Section 9,
Defective Pixel Correction, for the
details.
