CSI VCC-HD3, Техническое описание и руководство по эксплуатации

Страница: 9 / 30

VCC-HD3 Rev. 905-0051-Z0
©2016 CIS Corporation. All rights reserved.
8
7. GenLock
Input analog external sync signals (black burst or 3-value SYNC) to the EXT SYNC IN terminal of 6pins connector to
enable Gen Lock function.
The external sync signals to be supplied shall depend on its video output format, therefore, please refer to the chart
below and input appropriate signals.
EXT SYNC IN
CAMERA FORMAT
1080p60A 1080i60 720p60 1080p30
1080p59.9A NTSC 1080i59.9 720p59.9 1080p29.9
1080p50A PAL 1080i50 720p50 1080p25
1080p60B 1080i60 720p60 1080p30
1080p59.9B NTSC 1080i59.9 720p59.9 1080p29.9
1080p50B PAL 1080i50 720p50 1080p25
1080i60 1080i60 720p60 1080p30
1080i59.94 NTSC 1080i59.9 720p59.9 1080p29.9
1080i50 PAL 1080i50 720p50 1080p25
1080p30 1080i60 720p60 1080p30
1080p29.9 NTSC 1080i59.9 720p59.9 1080p29.9
1080p25 PAL 1080i50 720p50 1080p25
1080p24 1080p24
1080p23 1080p23.9
720p60 1080i60 720p60 1080p30
720p59.9 NTSC 1080i59.9 720p59.9 1080p29.9
720p50 PAL 1080i50 720p50 1080p25
･
Input Black Burst signals for NTSC/PAL signal.
・
Input 3-value SYNC signals for other than NTSC/PAL signal.
・
EXT SYNC IN is terminated with 75 Ω . (It becomes high impedance when camera power is OFF).
・
When the external signals specified above are input, the camera becomes external sync mode automatically.
・
When no external signal is input, the camera operates in internal sync mode.
・
The image may be disturbed right after the external signal is input, but this is not malfunction.
・
When a signal other than specified above combination is input to the EXT SYNC IN terminal, the image might be
disturbed or no image might be output.
8. LTC (Longitudinal Time Code)
･
Time code can be inserted into 3G/HD SDI signals.
･
Input LTC signals (time code) to the LTC IN terminal of the 6pins connector to insert external time code.
･
And, when no signal is input into the LTC IN terminal, internal time code can be inserted.
･
Internal time code starts with 00:00:00. 00 when power is ON, and when any signals are input into the
LTC IN terminal, it will be switched to the external time code.
･
With this situation, if no signal is input into the LTC IN terminal, it starts self-running from the set time code.
･
Signal Format: SMPTE Time code Signal Level: 0.5 ~ 2[Vp-p]