26
27
www.conferencesystems.com
• If the red LED flashes during the charging process, make sure that the unit
(CT-711 or CR-711) is firmly seated in the HC-32 charger. If charging a unit via
the adapter cable, ensure that the adapter cable is firmly seated in both the
unit (CT-711 or CR-711) and the HC-32 charger. If the red LED continues to flash
this may indicate that the NiMH batteries have reached the end of their life
cycle and need replacing.
•
Note that CT-711 and CR-711 units with NiMH batteries installed require an
uninterrupted 13-hour charging cycle before use
HC-316 charging/carrying case
•
Identify and locate the HC-316 charging/carrying case
•
You may charge up to 16 units (CT-711 transmitter/CR-711 receiver) using the
HC-316 charging/carrying case
•
Ensure that only NiMH batteries are installed inside the CT-711 and CR-711
units prior to charging
•
Ensure that the correct battery type is selected from the battery type selection
menu (see page 6.)
•
Power down the units (CT-711/CR-711) by pressing and holding the red button
on the left side of the unit until nothing is displayed on the LCD
•
Connect the AC adapter to the DC in slot on the side of the HC-316. Plug the
AC power cord into the AC adapter and a wall outlet
•
Place the units (CT-711 and/or CR-711) into the slots of the HC-316
charging/carrying case
•
When the units (CT-711 and/or CR-711) are charging, the LED indicators on the
units will flash on and off repeatedly. The LED will show a steady light when the
charging cycle is complete. The LED will turn off once the unit is removed from
HC-316 charging/carrying case
•
Note that CT-711 and CR-711 units with NiMH batteries installed require an
uninterrupted 13-hour charging cycle before use
•
Note that the HC-316 is ideal for charging, carrying, and storing CT-711
and CR-711 units. The HC-316 must be placed in a carton or container with
sufficient packing material for protection during shipment
Specifications
CT-711 and CR-711 Specs
•
LCD for display of channel selection, battery status,
and menu options
•
Up to 100 selectable channels
• Auto scan to find channels (CR-711 only)
•
Squelch Control with 10 preset levels to adjust RF
reception (CR-711 only)
•
360° rotating belt clip
•
Built-in charging circuit
•
RF Generation and control: PLL Synthesizer
•
Frequency Range: 625 to 650 MHz
•
Switching Bandwidth: 25 MHz
•
Channel Grid: 250 KHz
•
Modulation: FM
•
Peak Deviation: ±40 KHz
•
Compander: SA575
•
AF Frequency Response: 80 Hz to 15 KHz ± 3dB
•
AF Output: 1.2V (CR-711 only)
•
THD at 1 KHz: < 0.5% (CR-711 only)
•
Connector: mini-XLR (CT-711 only)
•
Connector: 3.5mm, 1/8 in. (CR-711 only)
•
Nominal Supply Voltage: DC 3V
•
Current Consumption: 120 mA
•
Battery: AA x 2 (Alkaline or NiMH)
•
Dimension (in): 7.48(L) x 2.56(W) x 1.38(H)
•
Weight (oz): 3.42
LED
