Conference System Incorporated EAST 1.800.614.7574 WEST 1.800.255.2111 www.conferencesystems.com
All specifications are subject to change without notice.
4
Technical Service Contacts
If technical service is needed, please
contact CSI. Pre-authorization is required before
returning CSI products.
If products were damaged in shipment, please
contact the carrier, then contact CSI for
replacement or repair requirements
payable by the carrier.
Toll Free: 1.800.614.7574
Telephone: 1.301.330.9090
Fax: 1.301.330.6901
Internet: www.conferencesystems.com
Service E-Mail: [email protected]
Mailing and Shipping Address:
Conference Systems, Inc.
12910 Cloverleaf Center Drive
Suite 100
Germantown, MD 20874
Technical Service Contacts & Compliance Notices
FCC ID Numbers
LT-800-216 (216 MHz base transmitter) ID: OMD800-003
PT-500-216 (216 MHz portable transmitter) ID: OMD700-003
Models LT-800, PT-500 and PR-500
These devices comply with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) These devices
may not cause harmful interference, and (2) these devices
must accept any interference received, including interference
that may cause undesirable operation.
LT-800 and PT-500 Transmitters
LT-800 and PT-500 transmitters are authorized by rule under
the Low Power Radio Service (47 C.F.R. Part 95) and must not
cause harmful interference to TV reception or United States
Navy SPASUR installations. You do not need an FCC license
to operate these transmitters. These transmitters may only be
used to provide: auditory assistance to persons with disabilities,
persons who require language translation, or persons in
educations settings; health care services to the ill; law
enforcement tracking services under agreement with a law
enforcement agency; or automated maritime
telecommunications systems (AMTS) network control
communications. Two-way communications and all other
types of uses not mentioned above are expressly prohibited.
Caution:
Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate CSI’s equipment.
FCC Statement
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
•
Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This equipment has been certified to comply with the limits for
a class B computing device, pursuant to FCC and IC Rules. In
order to maintain compliance with FCC and IC regulations,
shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely
to result in interference to radio and TV reception. The user
is cautioned that changes and modifications made to the
equipment without the approval of manufacturer could void
the user’s authority to operate this equipment.
Compliance Notices
Содержание PLS 500 series
Страница 23: ......
