SIGNATURE SERIES
10
-Starting an Immediate Regeneration Cycle -
• To Start Immediate Extra Cycle, press and hold the
SET / CHANGE
Button to zero out the meter, then repeat.
• After 3 Seconds the Regeneration Cycle will Begin
• The display will show the cycle step and minutes remaining (example “1-10”0 To skip ahead to the next cycle, press and
hold
SET / CHANGE
for 3 seconds.
-Flow Meter -
• Hold the
MENU / ENTER
button for approximately 3 seconds in order to view the flow meter.
0531
• The above example shows a water flow of 5.31 gallons per minute (gal/min).
Notes:
1. The smallest continuous detectable flow is approximately 0.35 gal/min.
2. The flow meter value can be affected by plumbing connections. The value should be considered approximate
and should not be used if a highly precise flow reading is needed.
• To exit the Flow Meter Menu press the
MENU / ENTER
button.
Note:
While in the Flow Meter Menu, if no buttons are pressed for 60 seconds or longer the menu will
automatically be exited.
-Battery Backup-
• To install the battery (standard 9-volt alkaline battery) the cover of the shuttle valve must be removed.
○
Next insert the battery into the battery holding area and snap the 9 volt battery connector onto the battery.
○
Replace the cover.
• Features of Battery Backup
○
The battery backup continues to count down gallons remaining during power failure.
○
If failure occurs while a valve transition is occurring. The battery backup allows a softener slave unit to motor
to a rest position that minimizes potential water flow during the power outage. Once power returns, the
softener valve will pick back up where it was when power was lost.
During power failures, the display is turned off to conserve battery power. However, to confirm that the battery is working, press either button and the
display will turn on for five seconds. When used without battery back-up, the unit acts like a standard mechanical valve—when a power failure occurs,
the unit stops at its current point in the regeneration position and then restarts at that point when the power is restored.
Service Information
