CSI CARDPIN1, Руководство по установке

Страница: 7 / 60

CSI Readers 1
Installation Guide Overview
Overview
I/NET uses several types of readers integrated into its system. Readers interface with
I/NET through connections to door processor units (DPUs). The reader type may be CSI
key/card, ABA, Watermark, Wiegand, Proximity, or I/DISC. These readers may attach to
a DPU-7910A series or DPU-7920 series controller. Most manufacturers’ readers may be
used with I/NET if they follow all protocol standards of one of the above mentioned
reader types.
Table 1 lists the I/NET DPUs and the readers compatible with each DPU.
For additional documentation concerning the use of these readers in the I/NET system,
refer to
“Related Manuals” on page 3 .
Signal Breakouts
All readers connect to the DPU either directly through a terminal block, or through a
breakout box plugged into an RJ45 connector. CSI provides two breakout boxes
providing either one or two RJ45 connections (CSI BRKBOX1 and BRKBOX2). The
screw terminals are numbered one to eight on both types of breakout boxes. The signal
breakout is provided in
Table 2 .
Table 1. I/NET DPUs and Compatible Readers
DPU Reader Type
DPU-7910A
Series
Controllers
CSI Key or Card
26-bit or 32-bit Wiegand
66-bit Wiegand with or without ESSEX PIN Pad
(requires DPU firmware version 2.20 or later)
Proximity
ABA
Watermark
I/DISC
DPU-7920
Series
Controllers
CSI Key or Card
26-bit or 32-bit Wiegand
66-bit Wiegand with or without ESSEX PIN Pad
(requires DPU firmware version 2.20 or later)
Proximity
ABA
Watermark
I/DISC
I/DISC with ESSEX PIN Pad (I/NET versions 4.3x and later)
48