CSI CARDPIN1, Руководство по установке

Страница: 40 / 60

Wiegand Readers Installation Guide
34 CSI Readers
9. Connect the cable shield using one of the following methods:
✧
DPU-7920 connection – When connecting the reader to a DPU-7920, connect
the shield directly to a good earth ground.
✧
DPU-7910A connection through a breakout box – When connecting the
reader to a DPU-7910A through a breakout box, connect the shield and earth
ground to terminal 2.
10. From a host workstation, configure I/NET to use the Dorado 780 swipe reader.
Common settings are:
✧
Reader Type: Wiegand 26-bit
Note: The LED Polarity settings described below apply to a DPU configured for three-color LED
control. Refer to TCON116 “DPU-7910A Installation Guide” or TCON117 “DPU-7920
Installation Guide” for three-color LED control information.
✧
LED Polarity (DPU configured for three-color LED operation):
– “Anode” for three-color LED control on the entry reader, two-color LED
control on the exit reader.
– “Cathode” for three-color LED control on both the entry and exit reader.
✧
Door Mode Schedule:
– “PIN Enable” to require both a card read and PIN entry
– “Secure” to require a card read only
✧
Key/Card Translation: If the DPU is configured to enable Wiegand 26-bit
key/card translations, perform these translations as necessary using the I/NET
Key/Card Translations editor. Refer to TCON116,
DPU-7910A Installation
Guide , or TCON117, DPU-7920 Installation Guide , for the necessary DIP
switch setting to enable Wiegand 26-bit key/card translations.
Figure 21. Dorado Model 780 Reader Connections
1
2
3
4 5
6
8
White
(DATA 1)
Red (+12 VDC)
From Reader
Yellow
(CONTROL B)
Black (GROUND)
Brown
(CONTROL A)
Green (DATA 0)
7
SHIELD
To DPU-7910A
Series Controller
+12 VDC
Linear Power
Supply
– +
Breakout Box Connections:
TB3 or TB4
1
2
3
4
5
6
7
8
White (DATA 1)
Green (DATA 0)
Brown (CONTROL A)
Yellow (CONTROL B)
Black (GROUND)
Red (+12 VDC)
From Reader
SHIELD
+12 VDC Linear
Power Supply
+
–
DPU-7920 Connections: