background image

1. WARNING - RISK OF EXPLOSIVE GASES
    a. Working in the vicinity of a lead-acid battery can be dangerous. Batteries generate explosive gases  

during normal batter operation.

    b. For this reason it is of the utmost importance that prior to each use of your charger, you read and 

follow the instructions provided exactly.

    c. The appliance is not intended for use by young children or infirm persons without supervision. 

Young Children should be supervised to ensure that they do not play with the appliance.

2. To reduce risk of a battery explosion, follow these instructions and those marked on the battery.

3. NEVER smoke or allow an open spark or flame in the vicinity of the battery or engine.

4. CAUTION - To reduce the risk of injury use the charger for charging a rechargeable lead-acid battery 

only. It is not intended to supply power to a low-voltage electrical system or to charge dry-cell 
batteries. May cause them to burst and cause injury and damage to property.

5. Do not expose the charger to moisture, rain or snow. Use in well-ventilated and dry area.

6. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a 

risk of fire, electric shock, or injury to persons.

7. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting 

the charger.

8. Make sure cord is located so that it cannot be stepped on, tripped over, or otherwise subjected to 

damage or stress.

9. Study all the battery manufacturers specific precautions such as removing or not removing cell caps 

while charging and recommended rates of charge.

10. Do not use the battery charger unless the battery voltage matches the output voltage rating of the 

charger.

11. Do not operate the charger in a closed-in area or restrict ventilation in any way.

12. An extension cord should not be used unless absolutely necessary. Use of improper extension cord 

could result in risk of fire and electric shock. If extension cord must be used, make sure.

      a. pins on the plug of extension cord are the same number, size and shape as plug on charger;
      b. That extension cord is properly wired and is in good electrical condition;

13. Do not operate the charger with damaged cord or plug. If the supply cord cannot be replaced and the 

cord is damaged, the appliance should be scrapped.

14. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in 

any way. Take it to a qualified repair station or dealer.

15. Do not disassemble the charger. Take it to a qualified repair station or dealer when service or repair 

is required. Incorrect reassembly may result in a risk of electric shock or fire.

16. To reduce risk of electric shock, unplug the charger from an outlet before attempting any 

maintenance or cleaning.

WARNINGS

Содержание CS1210L














Отзывы: