Crystal Vision Up-and-down-A, Руководство пользователя

Страница: 20 / 44

Crystal Vision
Card edge operation
Up-and-down-AAFD User Manual R1.22
19
17/11/2010
Video gains and offsets (Gain)
From the GAIN top menu press ENTER then SCROLL to access the video gain and
offset controls.
Menu Comment
R Gain
Rotate SCROLL to show RGain and press ENTER to select.
Rotate [ADJ] shaft encoder to set the R amplitude (80% to 120%).
Example:
RGain 100%
G Gain
Rotate SCROLL to show GGain and press ENTER to select.
Rotate [ADJ] shaft encoder to set the G amplitude (80% to 120%).
Example:
GGain 100%
B Gain
Rotate SCROLL to show BGain and press ENTER to select.
Rotate [ADJ] shaft encoder to set the B amplitude (80% to 120%).
Example:
BGain 100%
R Offset
Rotate SCROLL to show ROffst and press ENTER to select.
Rotate [ADJ] shaft encoder to set the R offset (0

20%).
Example:
ROffst 0%
G Offset
Rotate SCROLL to show GOffst and press ENTER to select.
Rotate [ADJ] shaft encoder to set the G offset (0

20%).
Example:
GOffst 0%
B Offset
Rotate SCROLL to show BOffst and press ENTER to select.
Rotate [ADJ] shaft encoder to set the B offset (0

20%).
Example:
BOffst 0%
Picture Crop
From the CROP top menu press ENTER then SCROLL to access the picture crop options
along with the closed caption and wide screen signalling controls. These controls act to
crop the input video so their action will be affected by the aspect ratio selection. Up to 31
lines of vertical crop both top and bottom are available and up to 31 pixels horizontally
both left and right.
When an aspect ratio is selected which results in a vertical shortening of the picture any
NTSC closed caption information would become visible and any horizontal scaling would
corrupt this information. The closed caption control if selected will blank lines 20 and 21
of the input video to remove this information from the visible picture and reinsert the
information in lines 20-21 of the output video so preserving its integrity.
PAL wide screen signalling on line 23 may also be selected for blanking.
Note:
The wide screen blanking control is only active when up-converting. In bypass mode
(SD-SD) the crop control will blank WSS data.