Crystal Mountain Storm, Руководство по обслуживанию

Страница: 24 / 33

5 - 7
4. Relax and remove the spring clip by using a plier (Figure 5-5-10). Remove the drain hose from
hot tank
,
if necessary.
Note: Hose may be difficult to remove. If necessary, use a flathead screwdriver to slide up between
the tube and pipe to release the hoses. Be careful not to damage hose.
5. With holding the hot tank on one hand, remove the 3 screws on the top shelf for hot tank (Figure
5-5-11).
6. Remove the hot tank from cooler (Figure 5-5-12).
7. While holding the new hot tank with one hand, align both tubes with the corresponding holes
(figure 5-5-13 and figure 5-5-14). Tighten the three screws to attach the hot tank properly.
8. Reconnect the drain hose and spring clips. Reconnect all wires as identified, if necessary refer
to the wiring diagram. Reinstall the steam valve and transparent outlet to top shelf. (Note: Make
sure the silicon seal on steam valve tube is installed properly.) Reinstall theSmartFlo™ SF-1 Water
Cartridge and turn the buttons to lock in place. Close and latch the locking arm. Close top cover.
Reinstall the back panel.
Figure 5-5-10
Figure 5-5-11
Figure 5-5-12
Figure 5-5-13 Figure 5-5-14