Crystal Mountain Storm, Руководство по обслуживанию

Страница: 23 / 33

5 - 6
Hot Tank Removal and Replacement
Note: Begin with the unit unplugged, the water drained and the back panel removed.
CAUTION: WATER IN HOT TANK IS VERY HOT AND CAN CAUSE SEVERE BURNS. ALLOW SUFFI-
CIENT TIME FOR THE HOT WATER TO COOL BEFORE DRAINING (1-2 HOURS).
Tip: Use a small flathead screwdriver to pry wire connectors off.
1. Use key (an accessory of the cooler) to open the top cover. Release and open the latch (Figure 5-5-
1). Turn to relax the 2 locking buttons (Figure 5-5-2 and Figure 5-5-3). Pull off theSmartFlo™ Water
Cartridge approx 4-6 inch high (Figure 5-5-4).
2. Nip the two clips to remove the transparent outlet (Figure 5-5-5). Remove the 2 screws (Figure 5-5-6).
Remove the steam valve and transparent outlet from top shelf (Figure 5-5-7).
3. Remove the 4 screws of thermostats (Figure 5-5-8). Note: Keep the thermostats away from other
things to prevent heat-transfer grease from being wiped off. Remove the ground wire from the hot tank
(Figure 5-5-9).
Remove and identify the 2 terminals at the bottom of hot tank.
Note: The terminals may be difficult to remove. Set an approx 1x1 inch (crossing size) block between the
flathead screw driver and hot tank bottom, it may be easier to operate.
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water
Cooler Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Figure 5-5-1 Figure 5-5-2 Figure 5-5-3 Figure 5-5-4
Figure 5-5-8 Figure 5-5-9
Figure 5-5-5 Figure 5-5-6 Figure 5-5-7