Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.022420
4 of 11
R
INTERFACING SOLUTIONS
VRFAD-81C
Front and Rear View Integration Interface
for AUDI Vehicles with MMI/MIB/MIB2 Systems
10. Plug the Pink or Gray LVDS cable to
the LVDS 1 cable. Plug the other end of
the LVDS 1 cable to the module LVDS
OUT.
11. Plug one end of the LVDS 2 cable
to the Pink or Gray LVDS port on the
media player. Plug the other end of the
LVDS 2 cable to the module LVDS IN.
12. Tap the Red and Black wires of
the VRFAD-81C harness to power &
ground:
Red to RED/YELLOW
Black to BROWN
14. Install the cameras that will be
used in the install. Run the camera
cables towards the radio. The RCAs and
camera power wires will be connected
to the VRFAD-81C harness.
Video Inputs Power Wire
Reverse Camera Pink
Front Camera Pink
Video Input Green
13. Tape the connections well to avoid
short circuits.
15. Connect the camera power wires to
the PINK power output 1 wire.
18. Test the cameras. Put gear in
reverse and check for rear camera
image on screen. Put gear in Drive
and the front camera should turn on.
Test AV source if image shows on the
screen.
Once the cameras and AV source
validation is complete, mount the
VRFAD-81C module, reinstall the media
player and glove compartment.
16. Plug in connectors to the VRFAD-
81C module.
17. Test the communication. Turn on
the ignition and check if LEDs are on.
