Use the RED/WHITE wire on the SOOGM-16V harness to power the cameras. Please see wiring diagram below:
SOOGM-16V
Radio Replacement with OnStar, SWC Retention and
Video Switcher for GM LAN 29 Bit Vehicles
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.122518
I/P Junc
tion B
ox
Reverse Gear Wire on
SOOGM-16V (RED/WHITE)
1N4001 Diode
Rear View Camera
+12V Power Wire
Front Camera
+12V Power Wire
(Optional)
1N4001 Diode
1N4001 diode is required
here if using a front camera.
1. Set the power mirror selection to off (both LED lights must be off on the power mirror
switch). You can turn off the LED by pressing the button on the same side that the LED
is currently lit. Note: Turning off the mirror selection will prevent the mirrors from being
adjusted while forcing the front/rear camera mode.
2. To force the Front camera mode, press and hold the Up arrow on the 4-way joystick
until the video shows on the aftermarket radio.
3. To force the Rear camera mode, press and hold the Down arrow on the 4-way joystick
until the video shows on the aftermarket radio. (If the vehicle is not equipped with a fac-
tory backup camera, an aftermarket backup camera can be installed and plugged into the
SOOGM-16V backup camera video harness)
4. To turn Off forced camera mode, press and hold the 4-way joystick Up arrow if in front
camera mode or Down arrow if in rear camera mode. Wait until the video turns off on the
aftermarket radio then release the 4-way joystick.
5. The reverse camera has priority over the front camera when driving the vehicle in
reverse.
1 (Requires installation of aftermarket camera)
FORCED CAMERA FEATURE:
The SOOGM-16V can force the aftermarket radio to show the front1 or rear video camera on select GM trucks and SUV’s
with power mirror controls at any time while driving. To force the front or rear camera while driving do the following:
To retain the use of the IR headphones with the factory overhead entertainment system you will need to connect a
+12 volt switched accessory power wire to the rear entertainment panel wire harness located in the rear of the center
console. You will need a 1 amp fuse and a 1N4001 diode to complete the installation. Remove the RSE control panel
in the center console. Tools will be required such as a panel remover tool and/or 7mm socket. Locate the (pink) wire
located in pin 14 of the (gray) connector. Connect the diode’s stripe side to the pink wire. Connect the other end of the
diode to one side of the 1 amp fuse. Connect the remaining side of the fuse to a +12 switched accessory wire. Refer
to the wiring diagram below.
ENABLING THE IR SYSTEM:
PINK WIRE
PIN# 14
1A
TO 12V
ACC
POWER
FUSE
1N4001
16 PIN RSE CONNECTOR
5 of 6