SOOGM-16V
Radio Replacement with OnStar, SWC Retention and
Video Switcher for GM LAN 29 Bit Vehicles
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
Reverse Gear Red/White
Parking Brake Yellow/Black
Illumina�on (+) Orange
+12V Constant Yellow
+12V ACC Red
Ground Black
Right Front (+) Gray
Right Front (-) Gray/Black
Le� Front (+) White
Le� Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Le� Rear (+) Green
Le� Rear (-) Green/Black
TO FACTORY
HARNESS
24-Pin
Connector
8-Pin
Connector
BOSE
NON BOSE
10-Pin
Connector
SWC DIP SWC CAM
1 2 3 4
ON
Video Out
Front Camera
Rear Camera
To OEM Camera
Harness
Brown 16-Pin
Connector
VIDEO HARNESS
Chime Volume
Adjustment
1 2 3
ON
VR Activation
for OnStar (set DIP#1 to ON)
4-Pin
Connector
Cap or insulate if
not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
LIN BUS (Green/Black)
JVC/Kenwood (Blue / Yellow)
Insulate if not
being used
If the vehicle is equipped with a Bose system, the SOOGM-16V
has a built-in Bose adaptor that allows the proper audio input
gain from the aftermarket radio to the Bose amplifier. To use
this feature, plug in the male 8-pin connector on the harness to
the GRAY female 8-pin connector on the SOOGM-16V module.
The module is also labeled “Bose” and “Non Bose” to avoid
confusion. (see picture below)
If the vehicle is NOT equipped with a Bose system, plug in
the male 8-pin connector to the BLACK female 8-pin on the
SOOGM-16V module.
Bose
Connection
Non Bose
Connection
SELECTING THE AUDIO SYSTEM:
2 of 6
rev.122518
