Operation Manual
I-Tech HD DriveCore Series
Power Amplifiers
page 26
cobraNet information:
This screen displays information about the
CobraNet network: The firmware version, ethernet status (down or up), and
conductor priority.
ch1 cobraNet Rx:
Tap the Encoder knob to set the number of the RxA
Bundle for Channel 1. Turn the right Encoder knob to set the CobraNet input for
Channel 1. The word “Active” appears if there is audio on the bundle. Bundles
1-8 are available at 48 kHz sampling rate, and bundles 1-4 are available at 96
kHz sampling rate.
cobraNet Tx:
Tap the icon then turn the Encoder knob to adj.
cobraNet conductor Priority:
Turn tap then turn the Encoder knob to set
the priority number of the CobraNet channel. Press the knob to confirm your
choice. See Section 12 for more on CobraNet conductor priority.
cobraNet Transport Latency:
Tap selection to set the CobraNet transport
latency: either 5.33, 2.66, or 1.33msec. Press the knob to confirm your choice.
This latency must match the Cobranet source for proper Cobranet reception.
7 Advanced Operation
7.2.5 COBRANET MENU
To access the CobraNet Menu from the Attenuation screen, press the Encoder
knob, then press
Prev
. This menu has selections for setting CobraNet
parameters. Press an Encoder knob to access the CobraNet Menu selections.
See Section 12 and the System Architect Help files for more on CobraNet.
