INSTALLATION AND OPERATION MANUAL, ELECTRIC SELF GENERATING SINGLE AND
TWIN STEAM MIXER KETTLE, MODELS ELTM-40 TO 100 AND ELTM 40-2 TO 100-2
Part No. 10041R4
16
2018-08-08
5.0 CLEANING INSTRUCTIONS
(Continued)
Use of cleaning agents that contain chloride, acids or salts are corrosive and may cause pitting
and corrosion when used over a period of time; this will reduce the life of the appliance.
Should pitting or corrosion occur, this is not covered by warranty.
Follow the recommended cleaning instructions. Use a mild detergent, warm water and
rinse thoroughly.
BUTTERFLY VALVE
WARNING: If you are cleaning a valve that is assembled to a
kettle, be sure the kettle is completely empty of any product.
DISASSEMBLY AND MAINTENANCE
In the event that repairs or replacement becomes necessary, the following procedures
are suggested.
1.
Drain and flush the piping surrounding the valve.
2.
To remove handle, remove the socket head screw found on top of the valve handle
with proper size Allen wrench.
3.
Remove the nut and cap screws.
4.
Separate the valve body halves.
5.
Set the butterfly disc to the open position.
6.
Squeeze the seal until oval shaped, then slide the short end of the stem from the seal.
7.
Pinch the disc between the thumb and forefinger and pull the long end of the stem.
8.
Check for and replace a cracked or worn seal, bushing, stem and disc, or screws.
9.
Reassembly is opposite of disassembly.
