INSTALLATION AND OPERATION MANUAL, ELECTRIC SELF GENERATING SINGLE AND
TWIN STEAM MIXER KETTLE, MODELS ELTM-40 TO 100 AND ELTM 40-2 TO 100-2
Part No. 10041R4
13
2018-08-08
4.0 OPERATION INSTRUCTIONS
(Continued)
OPERATION OF MIXER UNIT
Power to operate
the mixer unit is controlled by the “Main Power” switch located on the left
side of the control panel. Ensure that mixer “speed” control is set to the “stop” position.
Place switch in the “ON” position. Set the mixer switch, located beside the main power
s
witch, to “ON” position. Note that the agitators should not be turning. The speed control
has four basic settings which are: stop, slow, medium and fast. Set the speed control to the
slow position and observe that the agitators begin to turn.
CAUTION: Never place hands inside kettle when agitators are
in motion.
Increasing the speed setting on the control will increase the speed at which the agitators turn.
NOTE: Always start agitators at the slow speed and then gradually increase
to the desired s
peed to avoid splashing or “throwing” the product over edge
of kettle.
TO RAISE MIXER BRIDGE
To tilt kettle for emptying or to clean agitators, the mixer bridge will tilt hydraulically upward
and manually swing clear of the kettle. To do this, first
turn speed control to “STOP” and then
turn mixer switch to “OFF”.
NOTE: Mixer agitator arms must be stopped at 90 degrees to the
mixer bridge before raising the bridge. If the agitator arms do not
stop in this position when speed selector is set to stop
, then “jog”
the selector on and off to achieve this position.
Push the “TILT” switch to the “RAISE” position and hold. Bridge will raise to maximum
height. Bridge will stop at any position if the tilt switch is released and will remain in that
position until switch is pushed to either raise or lower. When the bridge is fully raised it
can be manually turned to the side to be clear of the kettle.
