INSTALLATION AND OPERATION MANUAL, ELECTRIC SELF GENERATING SINGLE AND
TWIN STEAM MIXER KETTLE, MODELS ELTM-40 TO 100 AND ELTM 40-2 TO 100-2
Part No. 10041R4
10
2018-08-08
3.0 INSTALLATION INSTRUCTIONS
(Continued)
ELECTRICAL CONNECTIONS
A control box with a power supply equivalent to the electrical rating of the unit should be located
nearby. A waterproof electrical connection for the power supply to the unit must be provided.
Remove the back panel of the hydraulic console and make electrical connection per
wiring diagram located inside the console in plastic bag attached to tank. A waterproof
electrical connection from power supply to rear of hydraulic console must be provided.
Ground kettle to terminal provided in the hydraulic console.
Once proper connections are made, replace the back panel on hydraulic console, turn
power ON and check for proper operation.
SERVICE CONNECTIONS
All internal wiring for the kettle and hydraulic power unit is complete.
Connect water supply for cooling system as shown in Service Connections.
If faucet is provided connect water supply and check for proper operation.
INSTALLATION CODES AND STANDARDS
Your electric mixing kettle must be installed in accordance with:
1. Provincial and local codes, or in the absence of local codes, with C.S.A. C22.1
Canadian Electrical Code, Part 1, or in the U.S.A., the National Electrical Code
ANSI/NFPA-70 (latest edition).
2.
ANSI NFPA Standard #96 “Vapour Removal from Cooking Equipment”, (latest
edition), available from the National Fire Protection Association, Batterymarch Park,
Quincy, MA, 02269.
