Crow OLED, Руководство пользователя

Страница: 9 / 27

7
Operating the Keypad
How to Arm the System before Exit
Preparing the System for Arming
Verify that all zone indicators are off, when all zones are closed (all doors, exits and windows are
closed and motion in the protected area is restricted or bypassed), the system is ready to be
armed. If one or more zone indicators are illuminated, it displays the open zones.
When system is ready, there is ready indication light at green.
Close open zones, or bypass them. Bypass any zone you cannot close. To see which zones
are in bypass mode, press or
Note: Bypassed zones are not protected.
Arming the System
Before leaving premises you must arm the system.
Arming the alarm system turns on all detectors in the partition/s being armed.
1. Enter your code.
2. Press to arm the system.
There is an exit delay prior to the system being armed. During this delay time, a slow
beeping is heard to indicate that the system is not armed yet and reminds you to vacate
the protected area.
The following writing lights up at the screen to indicate that the system is armed:
Armed A – for Area A, and Armed B – for Area B.
The indicators may go out few seconds after exit delay times out, depending on the installation
setting.
q
To disarm the system during the exit delay, press .
Quick Arm (When enabled at installation)
q
Press to arm the system.
During exit delay time, a slow beeping is heard reminding you to vacate the protected area.