Crow OLED, Руководство пользователя

Страница: 16 / 27

Operating the Keypad
14
Second press on this button, will exit to main screen.
How to Control Outputs and Devices
The keypad enables you to control external devices, such as an air-conditioner or heater. To
activate or halt a device:
1. Press <CONTROL>.
Control button can be one of the following buttons: , , , .
2. Press the number of the device.
This activates or deactivates the selected device.
3. Press <CONTROL>.
The LED is lit for each device ON.
4. Press the number of the device, to turn the device off.
Entering the User Program/Client Mode
There are 2 levels of program mode, CLIENT mode and INSTALLER mode. Normally the
installer gives you access to the CLIENT mode so you can add, delete, or change the user
codes. If you request it your installer can provide you with access to the INSTALLER mode as
well. To get into CLIENT mode provided the system is NOT armed Press enter Master code
and .
If you get a single long beep at this point, it means your code cannot access Program mode.
How to Exit Program Mode
To exit out of program mode press and .
How to Change or Add Codes
About Master Code and the User Code
The factory default master code (1234) is intended as a preliminary control of the alarm system.
After PowerWave is installed and put into service, the code can be changed to any code known to
the Master user. The Master user can define up to 100 user codes. To limit access rights, the
holder of the Master code can ask the installer to define several User profiles.
Access rights are listed below:
q
User code has Area A and/or B permission
q
User code can arm and/or disarm arm an area