CCpilot VS 12”
Product revision: A
Technical Manual
2017-11-23
www.crosscontrol.com
19
Figure 7: CCpilot VS 12” connectors
Connector pinouts are found in the following chapters.
6.1.
Deutsch DT connectors, general
Use caution and avoid plugging/unplugging Deutsch DT connectors while the device is powered up.
If a connector pin becomes bent the interface may not function correctly and the device should be
returned to the manufacturer for repair.
Pay close attention to the coding; violence or excessive force should not be used when mating the
connectors.
Note that the pin-order 1-12 in tables below are oriented as when looking at the receptacles from
the rear of the
CCpilot VS 12”
device, i.e. pin 1 at
top-left
position and pin 12 at
bottom-left
position,
see Figure 8.
Figure 8: DT connector pinout
The connector pins are rated for 13 A continuous current.
The DT connector pins are made of tin-plated brass. It is recommended to use tin-plated
receptacles in the mating connectors. Using different plating in the cable connectors might cause
galvanic corrosion.
Note that all three Deutsch DT connectors must be mated with its corresponding cable connector or
a proper blind plug to maintain the IP-classification.
