Cristofoli Vitale Plus 12, Инструкция по эксплуатации

Страница: 23 / 26

ATTENTION! For any replacement of parts, contact your local dealer or the authorized technical assistance office. It’s
strongly not recommended the replacement of any parts by non-qualified people. We have listed below the most
frequent problems and possible solutions the operator can try in his/her own office:
TROUBLESHOOTING
POSSIBLE CAUSES
SOLUTION
• No power ---------------------------------------------------------------------------
•The autoclave is not connected to the outlet ------------------------------
• The
Start key was not pressed to turn the equipment on ---------------
• The fuse has burned out ---------------------------------------------------------
• Defective electronic circuit ----------------------------------------------------
•·Check if there’s a power outage in your area/building;
•·Connect the power cable to the electrical outlet;
•·Press the
Start key, the initial information (brand, model and
software version) is shown on the display ;
•·Replace the fuse next to the power connector. In order to replace
the fuse, unplug the equipment, remove the fuse holder cap,
replace the defective fuse, screw the fuse holder cap back into
place and turn the equipment on;
•·See “
How to Proceed when Service is Needed ” (Page 24);
THE AUTOCLAVE DOES NOT SWITCH ON
POSSIBLE CAUSES
SOLUTION
• The operator connected the autoclave to the power source but
didn’t press the Start key -------------------------------------------------------
• Nothing happens when the Start key is pressed --------------------------
• The heating element has burned out ----------------------------------------
• Defective thermostat ------------------------------------------------------------
• Defective electronic circuit ----------------------------------------------------
•·Press the Start key after selecting the cycle on the Mode key;
•·See “ How to Use the Autoclave Vitale Plus ” (Page 13).
•·See “ How to Proceed when Service is Needed ” (Page 24);
THE AUTOCLAVE SWITCHES ON BUT DOES NOT HEAT UP
If the problem persists after the verification of all the items listed, contact your local dealer.
POSSIBLE CAUSES
SOLUTION
• Equipment installed where the altitude is above the
recommended ------------------------------------------------------------------
• In order for the autoclave to work properly, it is necessary to
perform the altitude calibration procedure. Calibrate the altitude of
the autoclave as shown on topic “
Altitude Calibration ” (Page 16).
THE AUTOCLAVE SWITCHES ON, HEATS UP BUT THERE’S NO PRESSURIZATION
• See “ How to Proceed when Service is Needed ” (Page 24); • Defective temperature sensor ------------------------------------------------
22
CRISTÓFOLI
A U T O C L A V E S
I N S T R U C T I O N M A N U A L