9
WIRING: 7-PIN Connector Cont.
PINK: (-) Diesel Glow Plug Input or Passive Carjack Input
GLOW PLUG INPUT: Diesel Vehicles Only (Option # 23)
There are 2 ways of configuring the
Wait to Start
circuit for Diesel vehicles.
1. Use the Pink wire to monitor the wait to start circuit of vehicle. Connect the Pink wire to vehicle’s wait to start
circuit that shows a (-) Signal while the “WAIT TO START LAMP” is on. When this wire is used, the system
will wait until light turns off before engaging the starter.
2. Use option 23 to control the wait to start circuit (pink wire not used). Most new vehicles have a computer
controlled wait to start circuit. There is no wait to start wire, only an indicator light on the dash that is not
accessible. These vehicles require a fixed time delay for remote starting. Selections are 10, 15 & 20 seconds,
or Monitor Pink Wire (Default).
PASSIVE CARJACK TRIGGER (Option # 32)
To use Carjack protection requires selecting Option 32-1. This changes the Pink wire to Carjack Mode. You must
connect the pink wire to a toggle switch or momentary switch to use Carjack protection.
Momentary Switch:
To Activate Carjack, the button must be pressed after the ignition turns on. Least protection
Toggle Switch:
Leave switch on for full time Carjack protection.
Connect the (-) Pink wire to a toggle switch or momentary push button depending on your level of Carjack
protection. When the pink wire is grounded with the ignition on, Carjack is armed. If a door is opened then
closed with ignition on, the Carjack Countdown will begin. After 1 minute, Carjack will trigger a full alarm.
To Reset Carjack During Countdown:
Press the UNLOCK button on the remote control, Carjack will reset and
the LED will stop flashing.
To Reset Carjack after Trigger:
With the ignition key on, press and hold the override button for at least 5 seconds.
Note: Carjack does not work in Valet Mode or while vehicle is Remote Started.
