10
WIRING: 2-PIN LED / 2-PIN Program-Valet Button (22 gauge wires)
Mount the Status LED in a visible location on the Dash or Console. Connect the small 2-pin plug from the LED to
the control module. Note: Connectors are designed so that they will only plug into their appropriate slots.
Mount the Valet/Program/Override button in a suitable location. Connect the 2-pin plug from the Switch to the
control module. Note: Connectors are designed so that they will only plug into their appropriate slots.
VALET / PROGRAM SWITCH
STATUS LED
WIRING 4 PIN OUTPUT CONNECTOR
BLUE/BLACK: (-) 500mA Ground When Running or Remote AUX #2 (Programmable Option #17)
This is a programmable output that can operate 2 different ways.
1- Ground when Running = Default.
This is used for Remote Start when connecting factory Security Bypass
modules or when an additional external Ignition Relay is required for your installation.
2- AUX 2 Remote Output -
This wire can be programmed to function as Auxiliary Channel #2 output. This output
stays on as long as the button is held down. Connect to the Negative activation circuit of an auxiliary module or
device.
BLUE/ORANGE: (-) STARTER Output
This wire provides a ground output for vehicle that requires a third starter wire to remote start.
VIOLET/WHITE: (-) ACC or AUX. 3 (Default = ACC)
The Violet/White wire is selectable for ACC, Momentary Pulse, Timed or Latched output, depending on option used.
Option #27 and 28 controls these functions.
GREEN/WHITE: (-) IGN or AUX. 4 (Default = IGN)
The Green/White wire is selectable for IGN, Momentary Pulse, Timed or Latched output, depending on option used.
Option #29 and 30 controls these functions.
