TRANSMITTER / 3 SEC. DOOR LOCK PROGRAMMING
TRANSMITTER CODE PROGRAMMING
Note: The system can learn up to 4 different codes max.
1. Have system DISARMED/UNLOCK and Ignition OFF before attempting these steps.
2. Turn Ignition ON and OFF 3 times quickly, leaving it ON the last time. (ON/OFF, ON/OFF, ON) You should hear
(1) short chirp.
3.
Wait at least 2 seconds, then push and release the Program/Override Button. The siren should chirp (4) times for
confirmation.
The system is now in programming mode.
4. Press Button #1 on new transmitter twice. Siren will chirp to confirm code learn.
5. Turn off Ignition and wait about 10 seconds before trying the remote. Repeat Steps 2-5 for another transmitter.
The system will learn up to 4 remotes.
3 SEC. DOOR LOCK/UNLOCK PULSE
Note: System also learns a code when this feature is changed.
A 3-second Door Lock/Unlock pulse may be required for some 1980-90’s European Vehicles with Vacuum door lock
systems. Factory default Door Lock/Unlock pulse is 0.75 sec.
1. Follow Steps 1 through 4 above.
2. Press the override/program button again and hold until the siren chirps twice (Instead of turning Off Ignition).
3. Turn Off Ignition after the (2) chirps are heard.
4. The System should now have a 3-second lock and unlock pulse. Repeat this procedure to revert back to 0.75 Sec.
Note: You may Choose to perform this change when adding a new transmitter to the system or just
reprogram (re-learn) one of the existing remotes.
JUMPER PLUG PROGRAMMING
JUMPER PROGRAMMING:
Insert or remove jumpers to control 2 VEHICLE & PASSIVE CARJACK features.
J9 - PASSIVE CARJACK:
Jumper inserted = Passive Carjack ON / Jumper removed = Passive Car Jack OFF. (See diagram on next page.)
See Operation/Owner’s manual for Passive Carjack information.
J10 - 2 VEHICLE OPERATION:
Jumper inserted = 2 Vehicle Mode ON / Jumper removed = 2 Vehicle Mode OFF. (See diagram on next page.)
Insert this jumper before programming for 2 VEHICLE operation. Allow transmitter to operate another RAGE system
with Channel 3 (Buttons 1&2 together). See 2-Vehicle Programming for more information / code-learn procedures.
NOTE: These features are lost when
SILENT ARM / DISARM ON CHANNEL (Buttons 1&2)
2 Vehicle operation is programmed:
VALET / VALET PARK Through the remote
PRE-WARNING SENSOR DEFEAT Through the remote.
