2 VEHICLE PROGRAMMING
PREPARING THE TRANSMITTERS
1. Take the transmitter to be used for Vehicle #1 and set them aside. No modifications are necessary.
2. Open the transmitters for Vehicle #2 and solder the “2 VEH” pads together on each. This designates these
transmitters as Vehicle #2.
CRI M
ESTOPPER
C
R
I M
ESTOPPER
SECURI TY PROD. I NC.
LED
BACK/BOTTOM
M
ADE I N U. S. A.
SECURI TY PRO
D
U
C
TS
OF CS-231BDC
+
VC1
FRONT/TOP
OF CS-337DC
2- VEH
2- VEH
SOLDER PADS
2 VEHICLE
BULLET TX
KIDNEY TX
PROGRAMMING: VEHICLE #1
1. Make sure both remotes for VEH 1 operate VEH 1.
2. Program both VEH 2 remotes to VEH 1. See Transmitter Code Programming.
3. Make sure all remotes operate VEH 1.
4. Insert Jumper onto “J10” pins.
5. Retest the remote controls
VEH 1 Remotes should operate this system with button #1
VEH 2 Remotes should now operate this system with buttons #1 & #2
If this does not operate as described above, re-check solder pads verify they are connected.
PROGRAMMING: VEHICLE #2
1. Make sure both remotes for VEH 2 operate VEH 2.
2. Program both VEH 1 remotes to VEH 2. See Transmitter Code Programming.
3. Make sure all remotes operate VEH 2.
4. Insert Jumper onto “J10” pins.
5. Assign VEHICLE 2’s Control Module as VEH 2 in programming option 10. See page 9.
5. Retest the remote controls
VEH 2 Remotes should operate this system with button #1
VEH 1 Remotes should now operate this system with buttons #1 & #2
