WIRING
GRAY WIRE: (-) AUX REMOTE OUTPUT 1 (Optional,
requires relay)
Connects to terminal 85 of a relay. Connect terminal 86 to constant. Connect terminal 87 to +12V constant or ground
depending on the type of circuit that needs to activated. Connect terminal 30 to the device/circuit to be activated.
GREEN WIRE: (-) DOOR TRIGGER
Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles may
have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to the
wire that triggers the vehicle’s dome light.
BLUE WIRE: (-) HOOD/TRUNK TRIGGER
This wire is an input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches
that read ground when open. If no existing switches are available, install new pin switches. Note: DO NOT mount new
pin switches in water pathways.
VIOLET WIRE: (+) DOOR TRIGGER
Same as GREEN wire above except this wire is used for vehicles that show a positive voltage (12 volts) when the door
is open such as Ford.
YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS
Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start”
positions.
4 PIN PLUG: (-) OPTIONAL FEATURES / ACCESSORY WIRING
WHITE WIRE: PARKING LIGHT OUTPUT #2 (Optional, European Vehicles)
This wire is used on European vehicles that require left and right isolated parking light output circuits. Connect this
wire to the 2
nd
half of the circuit from where the other WHITE wire (Main Harness) is located.
WHITE/ORANGE WIRE: REMOTE OUTPUT 2 or MOBILE ACC. PROTECTION (Optional, Requires Relay)
This wire is programmable to operate in two different ways: 1. Remote Auxiliary Output 2 providing a (-) Negative
Momentary Output with a Double-Press of Button 2 on the remote control. 2. M.A.P. providing a continuous (-)
Negative output when in VALET PARK MODE. Interrupt power/accessory wiring to prevent unauthorized access of
the vehicle’s audio or entertainment systems when Valet Park mode is ON.
WHITE/GREEN WIRE: Dome Light Illumination (Optional, Requires Relay)
Connect to terminal 85 of relay. Connect terminal 86 to constant. Connect terminal 87 to +12V constant or ground
depending on the type of dome light circuit in the vehicle. 30 to the dome light circuit.
WHITE/BLACK WIRE: (-) HORN HONK OUTPUT (Optional, requires relay)
Connects to terminal 85 of a relay. Connect terminal 86 to +12V Constant. Connect terminal 87 to +12V or ground
depending on the type of horn activation circuit in the vehicle. Connect terminal 30 to the horn activation circuit.
