Fermod Floor Guided Sliding Door Hardware Kits -
F2156 Installation Guide
www.crh.com.au
16
Step 11.
Attach the main rail to the rail holder brackets.
1. Slide the 3 fixing nuts into the main rail profile
and attached each using the bolts & washers
provided.
2. Adjust the end of the closing side to the
distance shown in fig.B
3. Refer to drawing on page 3 for the distance
from the support rail to the face of the main rail,
(89.5mm).
4. Tighten the fixing screws.
Note:
After hanging the door the installer may find that
the top gasket is tight against the frame causing
the bottom of the door to be pushed outwards.
This will affect the performance of the door. In
this case, loosen the top bracket screws and
adjust the top rail outwards.
Fig.B
CLOSING SIDE
Fig.A
A9
A8
149
