CRETE BOWL CFB120LP, Руководство пользователя

Страница: 8 / 25

SET-UP
2. CONNECT A GAS LINE
THIS APPLIES TO BOTH LIQUID PROPANE & NATURAL GAS INSTALLATION: Your fire table will arrive with the burner and
burner plate set in the fire table. You will need to lift it up to access the gas inlet. The gas line between the burner and the gas valve located
on the side of the fire table has been connected for your convenience.
2.a. CONNECTION FOR LIQUID PROPANE
We recommend installation is completed by professionals that are locally licensed by the authority having jurisdiction in gas piping.
Follow all local codes. Unless you have a permanent liquid propane gas line installed, you will need to run the black liquid propane gas
line under the base of the fire table through the air gap space that is located in between the base of the unit and flooring surface.
The flex line that runs from the gas valve to the burner has been connected at the factory. You will only need to connect the
propane line from the gas valve to the propane tank. Perform a leak test before replacing the burner plate. (See below) Connect the
black liquid propane hose to a gas cylinder. Use a OCC-1 propane connector with a regulator. When you connect the regulator to
the tank valve, hand tighten the black OCC-1 nut clockwise. DO NOT use a wrench to tighten. If you are unable to run an
in-ground gas line you may have to run the gas line through the air vent. This is fine, as long as the gas line is the only thing going
through the vent.
2.b. CONNECTION FOR NATURAL GAS
The flex line that runs from the gas valve to the burner has been connected at the factory. You will only need to connect the natural
gas line from the gas valve to the gas source. Perform a leak test before you replace the burner plate. (See below).
3. PERFORM A LEAK TEST
Perform a leak test at least once a year whether the gas supply cylinder has been disconnected or not. In addition, whenever the gas
cylinder is connected to the regulator or whenever any part of the gas system is disconnected or replaced, perform a leak test. As a safety
precaution, remember to always leak test your fire table outdoors in a well-ventilated area. Never smoke or permit sources of ignition in the
area while doing a leak test. Do not use a flame, such as a lighted match to test for leaks. Use a solution of soapy water.
3.1. Prepare a leak testing solution of soapy water by mixing in a spray bottle one part liquid soap to one part water. Make sure all
the control knobs are in the OFF position.
3.2. Turn on the gas.
3.3. Apply the leak-testing solution by spraying it on joints of the gas delivery system.Bubbles in the solution will show you where
leaks are present.
3.4. Stop a leak by tightening the loose joint or by replacing the faulty part with a replacement part recommended by the
manufacturer. Do not attempt to repair the cylinder valve if it is damaged. The cylinder must be replaced.
3.5. Turn the control knob back to the full OFF position. If you are unable to stop a leak: Turn the control knob back to the full
OFF position. Shut off the gas supply to the fire table and release pressure in the hose and manifold. On propane systems, remove
the cylinder from the fire table. Call an authorized gas appliance service technician or a liquid propane gas dealer. Do not use the
appliance until the leak is corrected.
08
User’s Manual
715-293-3101
info@crete.design