CRETE BOWL CFB120LP, Руководство пользователя

Страница: 9 / 25

SET-UP
4. PLACE DECORATIVE STONE IN FIRE TABLE SET-UP
After you have completed all plumbing installation, you can fill the fire table with the decorative filler material provided. Type of filler
placement, such as lava rock, decorative stone or glass, is entirely your choice according to your preferences, but it needs to be rated for use
with fire. It will not affect the operation of the fire table in any way. You can place the filler material on the burner, but no higher than 1”
thick. Excessive filler material may impede gas flow and cause gas build-up and potentially cause an explosion.
Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the burner, it will take a few seconds
for the lines to purge themselves of this air. Once the purging is complete, the burner will light and operate as indicated in the instruction
manual. Subsequent lighting of the appliance will not require purging unless the gas supply has been disconnected.Inspect the gas hose
before each use of the fire table. If the hose shows evidence of excessive abrasion or wear or if the hose is damaged, it must be replaced
before using the fire table .Inspect the burner before each use of the appliance. If there is any evidence that the burner is damaged, it must
be replaced before operating. Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the
burner, it will take a few minutes for the lines to purge themselves of this air. Subsequent lighting of the appliance will not require such
purging. Never allow the ON/OFF valve to remain in the open position without placing a burning match on top of the burner FIRST! You
must have clear and easy access to the ON/OFF valve AFTER the appliance is installed and connected to the gas supply in order to safely
turn off the burner.Make sure the burner is in place prior to using the appliance. If the burner is damaged, install a replacement burner as
specified by the manufacturer.
FOR YOUR SAFETY, READ BEFORE LIGHTING:
Before operating the fire table, smell around the appliance area for gas odors. Be sure to smell the surrounding floor area as some gases are
heavier than air and will settle on the ground.• Use only your hand to turn the manual gas control valve. Never use tools. If the valve will not
turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.
5. LIGHTING INSTRUCTIONS
5.1. Turn the ON/OFF valve located on the side of the fire table completely to the ON position.
5.2. Make sure fuel supply (LP or NG) is properly connected and turned on at the source. This will be either the LP tank or the NG
valve.
5.3. When you hear gas flowing, use either a long stem wooden match or a butane fireplace lighter to place a flame near the burner.
5.4. If the burner does not light, does not stay lit, or the flame is very low, shut off the gas supply and wait five minutes to allow all
fumes to clear. Start again from Step 1, making sure all gas valves are completely opened.
TURNING OFF GAS
For NG Units: Turn the ON/OFF valve to the OFFposition at the unit for natural gas unit, then close the valve at the NG source.
For Propane Units: Turn the ON/OFF valve to the OFF position at the unit and then close the valve on the propane tank.
NOTE: The propane regulator in this appliance is equipped with a low flow protection device. Unless the propane cylinder valve is
opened before the valve, the gas flow will be reduced resulting in a very small flame.To reset this device, shut off the valve,
disconnect the hose from the cylinder to relieve the pressure, then close the propane cylinder valve.
09
User’s Manual
715-293-3101
info@crete.design