Crestron TPMC-10, Руководство по эксплуатации, Страница: 21 / 60

Crestron TPMC-10 Isys i/O
™
WiFi Touchpanel
Depending on the size of the installation and the conditions that affect the quality of
communications, it may be advisable to include additional access points, range
extenders, or repeaters to ensure that the TPMC-10 can communicate with the
system from any location within the facility.
The following diagram presents a more complex configuration. In this scenario, the
WAP is connected to an A/V subnet. Port B of the control system’s C2ENET-2 card
is also connected to the A/V subnet. Port A is connected to the corporate LAN. The
card’s internal firewall controls data flow thus isolating the two subnets.
NOTE: When using a dual-port Ethernet card, Ports A & B must be different
subnets (Port A = 192.168.1.1; Port B = 192.168.2.1).
For additional information on setting up and understanding an Ethernet network,
refer to Doc. 6052, Crestron e-Control Reference Guide. It may be downloaded from
the Crestron website (
www.crestron.com/manuals) .
To set up a WAP on the B-side of the C2ENET-2 dual-port Ethernet card, do the
following:
1. Configure an IP address on port B (refer to the latest version of the Crestron
C2ENET-1/-2 Operations and Installation Guide (Doc. 5962).
2. Configure the WAP to be on the same subnet as port B; use port B’s address
as the default gateway.
3. Configure the TPMC-10 to connect to the WAP (refer to “WiFi SETUP” on
page 13).
4. Configure the IP table in the TPMC-10 to point to the port B address.
Operations Guide – DOC. 6284B Isys i/O
™
WiFi Touchpanel: TPMC-10
•
17