Crestron QM-WMIC, Руководство по эксплуатации и установке

Страница: 12 / 32

Wall Plate Media Center Microphone Input Crestron QM-WMIC
Installation
The QM-WMIC is designed to connect to a dedicated connector on the
rear of the QM-WMC Wall Plate Media Center.
The following tools/hardware are required for installation.
•
Wire nut (not supplied)
•
Phillips screwdriver (not supplied)
•
Two ¾” pan head Phillips screws (supplied)
NOTE: The QM-WMIC can be installed when the QM-WMC is being
installed or after the QM-WMC has been installed. The following
procedure is written for a scenario where the QM-WMIC is being
installed at the same time as a QM-WMC. Detailed installation
instructions for the QM-WMC can be found in the latest revision of the
QM-WMC Operations & Installation Guide (Doc. 6237) which can be
downloaded from the Downloads | Product Manuals section of the
Crestron website (
www.crestron.com ).
NOTE: If the QM-WMIC is to be installed into an existing QM-WMC
installation, all electronic connections to the QM-WMC should be
removed prior to removing the QM-WMC from its two-gang electrical
wallbox. A three-gang box must replace the two-gang electrical wallbox.
1. Turn Cresnet system power OFF .
2. Place the QM-WMIC next to the QM-WMC as shown in the
following diagram.
8
•
Wall Plate Media Center Microphone Input: QM-WMIC Operations & Installation Guide - DOC. 6245