20 • IV-CAMFL-N-W-1B
Product Manual — Doc. 9321A
Tracking Settings
Now that the camera is connected and streaming video to the host computer, click Stop in the
lower left corner to stop tracking and to enable settings.
To access the camera’s tracking properties, click Settings. The tracking settings panel opens and
shows a full view of the room with the Tracking Zone shown as a green rectangle.
Set the Tracking Zone
Requirements:
l
Set the Tracking Zone to contain the entire area where a presenter will move around.
Draw the Tracking Zone so it fills a presenter's head and torso.
l
Leave room on the left and right of the zones to allow the presenter to leave the zone and
another presenter to enter.
l
If the front row of audience seats covers some of the presentation area, don’t include it in
the Tracking Zone. Instead, draw it so that at least the torso and/or head of the presenter
will be the only moving subjects in the Tracking Zone.
NOTE: The camera does not auto-save settings. Make sure to save frequently during the
setup process.
To draw a Tracking Zone:
1. Click Tracking (Lecturer) in the lower half of the settings panel. The cursor will move into
the video frame.
2. While holding down the left mouse button, drag the mouse to draw the tracking zone.
3. Let go of the left mouse button to release the cursor from the video frame.
4. Once the Tracking Zone is set, click Save to store the setting in the camera’s memory.
Set the Blocking Zone
Set Blocking Zones within the Tracking Zone to prevent projection screens, windows, or moving
objects from triggering the camera’s motion detection. Up to 8 blocking zones can be configured.
Guidelines:
l
Blocking zones should cover the entire display or projection screen that falls within the
tracking zone.
l
Set the Blocking Zone so it does not block an entire section of the tracking zone, as this
could potentially cause the camera to lose the presenter if they remain in the blocked area
for too long.
l
There should be space left in the Tracking Zone below the Blocking Zone so that motion
can be tracked as the person walks in front of the display or window you are blocking.
To set up a Blocking Zone, click on one of the check boxes in the Blocking Zone area of the
settings pane and draw the zone in your desired spot within the tracking zone. This process is
identical to setting up the Tracking Zone.
