Crestron DIN-GWDL, Руководство по эксплуатации продукта

Страница: 27 / 40

Product Manual — Doc. 9096A DIN-GWDL and DIN-GWDL-SPLTR • 27
Cycle Intensity, CCT, Saturation, and Hue
NOTE: This requires all DMX-C fixtures to be new from the factory or to have been previously
addressed by Crestron Home.
Use PG2 to continuously cycle through intensity, CCT, saturation, and hue settings on all
connected fixtures. This mode can be used to test system wiring and verify that there are no
defects with connected light fixtures. PG2 stops the program, ignores any network commands,
and turns off all addresses on the DALI output. The intensity, CCT, saturation, and hue are set to
0 for all connected fixtures.
l
Each value individually ramps over 10 seconds, in this order:
o
Intensity: 0%-100%
o
CCT: 1650K-8000K
o
Saturation: white to red
o
Hue: all colors
o
Intensity: 100%-0%
l
Press SELECT to pause or resume the sequence.
Everything Off
Use OFF to turn off all connected lighting fixtures. OFF also stops the program and ignores any
network commands.
Test DMX 1 Output
Use DMX 1 to test all light fixtures connected to the DMX 1 output. DMX 1 stops the program,
ignores any network commands, and turns off all fixtures connected to the DMX 2 output by
setting all DMX 2 channels to 0. This also turns on (red) all fixtures connected to the DMX 1
output by setting all DMX 1 channels to 255.
l
Tap SELECT to set all channels on DMX 1 to 0 or 255 (off or red).
l
Hold SELECT to ramp all DMX 1 channels up or down.