Crestron DIN-GWDL, Руководство по эксплуатации продукта

Страница: 10 / 40

Product Manual — Doc. 9096A DIN-GWDL and DIN-GWDL-SPLTR • 10
Communications
DMX-C Supports discovery, auto-addressing and fixture data;
DMX-C communications with Crestron light fixtures and Crestron compatible
third-party light fixtures
Ethernet 100BASE-TX Ethernet;
Static IP or DHCP
Connections
LAN PoE Class 2 (1) 8-pin RJ-45 connector, female;
100BASE-TX Ethernet port;
PoE (Power over Ethernet) PD (Powered Device)
9-48VDC (1) 3-pin 5.18 mm terminal bock;
9 - 48VDC, 5 W max;
Use only when not powering the device using PoE
DMX 1-2 (2) 3-pin 5.18 mm terminal blocks;
Isolated DMX-C outputs;
One universe split between two ports;
Each output supports up to 32 directly connected devices
Wiring:
Use shielded CAT5 wire or better with a shielded connector, do not connect
drain to ground;
24 AWG minimum;
RJ-45 to 3-pin adapters included to make CAT5 STP connections;
Daisy chain all fixtures, do not create loops;
1,000 ft (305 m) maximum per output
Termination:
Terminate all daisy chain runs with the termination resistor included with the
fixtures;
Terminate the connection to a DIN-GWDL-SPLTR with the 120 Ω termination
resistor included with the DIN-GWDL-SPLTR between the + and - pins on the
terminal block that connects to DMX IN
INPUTS and OUTPUTS (1) 8-pin 5.18 mm terminal block, shared between INPUTS and OUTPUTS
INPUTS 1-2:
(2) inputs for contact closure, INPUT 1 contact controls Override mode and
INPUT 2 contact controls the lights when Override mode is on;
INPUT 1: When the contact is closed, Override mode is turned on. When the
contact is open, Override mode is turned off and the lights operate normally;
INPUT 2: When the contact is closed, the lights turn off. When the contact is
open, the lights turn on
OUTPUTS 1-2:
(2) individually isolated (1KV) relay outputs (48V 250mA);
Repeats signal from corresponding INPUT 1 or 2;
Connect to additional DIN-GWDL INPUTS or other device override inputs
N/A Not used