Crestron DigitalMedia DM-TX-300N, Руководство по эксплуатации

Страница: 34 / 44

DigitalMedia™ CAT & Fiber Transmitters 300N Crestron DM-TX-300N/-F
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade it is necessary to establish
communication. Once communication has been established, files (for example,
firmware) can be transferred to the device. Finally, program checks can be
performed (such as changing the device ID or creating an IP table) to ensure proper
functioning.
Establishing Communication
Use Crestron Toolbox for communicating with the DM-TX-300N/-F; refer to the
Crestron Toolbox help file for details. There is a single method of communication:
TCP/IP communication.
The DM-TX-300N/-F has an internal Ethernet switch. It can be connected via
Ethernet or DM, as shown in the following illustration.
Internal Ethernet Switch Allows Connection via Ethernet or DM
DM-TX-300N/-F
CPU
Ethernet
Switch
LAN
“M” connection
Ethernet Communication
Ethernet
PC Running
Crestron Toolbox
DM-TX-300N/-F
The DM-TX-300N/-F connects to PC via Ethernet:
1. Enter the IP address, IP mask and default router of the DM-TX-300N/-F via
the Crestron Toolbox ( Functions | Ethernet Addressing ); otherwise enable
DHCP.
NOTE: Use the Device Discovery Tool in Crestron Toolbox to detect all Ethernet
devices on the network and their IP configuration. The tool is available in Toolbox
version 1.15.143 or later.
2. Confirm Ethernet connections between DM-TX-300N/-F and PC. If
connecting through a hub or router, use CAT5 straight through cables with
8-pin RJ-45 connectors. Alternatively, use a CAT5 crossover cable to
connect the two
LAN ports directly without using a hub or router.
30
•
DigitalMedia™ CAT & Fiber Transmitters 300N: DM-TX-300N/-F Operations Guide – DOC. 6907D