Crestron DigitalMedia DM-TX-100F, Руководство по эксплуатации

Страница: 16 / 36

DigitalMedia™ CAT & Fiber Transmitters 100 Crestron DM-TX-100/-F
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
12 G (1) 6-32 screw, chassis ground lug
13
DM OUT
4, 10
(1) DM fiber output composed of (2) SC
female fiber optic connectors;
Connects to DM fiber input of a DM switcher,
receiver/room controller or other DM device
via CresFiber fiber optic cable
11
14 G 24
4, 12
(1) 2-pin 3.5 mm detachable terminal block,
24 Volt DC power input
Connects to local power supply (included) or
to DMNet port (
24 and G only) of a DM
switcher
1. Interface connectors for IR, G B A 24 (DM-TX-100) and G 24 (DM-TX-100-F) ports are provided
with the unit.
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI or DisplayPort
Multimode signal. CBL-HD-DVI and CBL-DP-HD interface cables sold separately.
3. To determine which is pin 1 on the cable, hold the cable so the end of the eight pin modular jack is
facing away from you, with the clip down and copper side up. Pin 1 is on the far left.
4. DM-TX-100-F only.
5. DM-TX-100 only.
6. The DM OUT port consists of two separate RJ-45 connectors labeled D and M . The D port carries
HDMI signal. The M port carries data. Refer to the following tables for the connector pinouts.
D and M Port Wiring
1 8
PIN # WIRE COLOR PIN # WIRE COLOR
1 Orange/White 5 Blue/White
2 Orange 6 Green
3 Green/White 7 Brown/White
4 Blue 8 Brown
7.
For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to two DM Repeaters, model
DM-DR (sold separately) may be required. Refer to the latest version of the Crestron DigitalMedia
Design Guide (Doc. 4789) for complete wiring guidelines.
8. DMNet wiring is not compatible with Cresnet wiring. DMNet wiring cannot be daisy chained.
12
•
DigitalMedia™ CAT & Fiber Transmitters 100: DM-TX-100/-F Operations Guide – DOC. 6810C