Crestron
AV2 & PRO2
2-Series Integrated Dual Bus Control System
Complete the procedure below to attach ears to the unit. The only tool required is a
#2 Phillips screwdriver.
1. There are 12 screws (#6-32 x 0.375" LG) that secure the sides of the
2-Series control system top cover. Using a #2 Phillips screwdriver,
remove the three screws closest to the front panel from one side of the
unit.
2. Position a rack ear so that its mounting holes align with the holes
vacated by the screws in step 1.
3. Secure the ear to the unit with three screws from step 1, as shown in the
illustration after this step.
Ear Attachment for Rack Mounting (PRO2 shown in illustration)
FASTEN WITH THE SAME (3) COVER SCREWS
RIGHT SIDE VIEW OF PRO2 WITH
OPTIONAL RACK MOUNTING EARS INSTALLED
4. Repeat procedure (steps 1 through 3) to attach remaining ear to
opposite side.
Expandable Memory
The onboard 36MB memory of the 2-Series integrated dual bus control system is
enhanced with a 4GB expansion slot that supports off-the-shelf Type II compact
flash memory and the IBM Microdrive
hard drive. The slot is accessible on the rear
panel of the unit. Complete the procedures in the following subsections to install and
remove the memory cards. Power does not have to be disconnected to insert or
remove memory. The memory supports FAT32 file structure.
Memory Card Installation
1. Loosen the screw that secures the memory slot cover located to the left
of the
COMPUTER
port on the rear panel.
2. Pull on the screw to remove the screw and cover.
3. Observe handling precautions of the memory card manufacturer and
insert into the open slot.
4. Align and reposition cover over slot.
5. Tighten the screw.
Operations Guide - DOC. 5957
Integrated Dual Bus Control System: PRO2 & AV2
•
13
Содержание 2 Series
Страница 1: ......
