27
Amplitude changes up to + and – 6 dB, in 0.5 dB increments.
Filter Types for each band include:
Bell (parametric), with Q ranging from 0.4 to 20
Hi Shelf, with Q ranging from 0.1 to 3.5
Lo Shelf, with Q ranging from 0.1 to 3.5
Low Pass, with Q ranging from 0.1 to 3.5
High Pass, with Q ranging from 0.1 to 3.5
Notch Filter, with Q ranging from 4 to 72
All-Pass1, a 1
st
order all-pass filter, no Q adjust (it’s 1
st
order)
All-Pass2, a 2
nd
order all-pass filter, with Q ranging from 4 to 72
Each band has a Bypass button (
Byp
) at the bottom of the EQ strip, which turns off the EQ band
changes to make that band “flat”, then with another click, that EQ band action is turned back on.
There is a
Bypass
checkbox for overall bypass of the entire EQ section at once, which toggles the
EQ on and off. This is located at the top right-hand side of this section.
There is an
EQ
Flat
button for returning all the bands and settings to 0 dB, but this button does NOT
toggle, if clicked, the EQ settings are lost, and you start over again.
If you should accidently click this button, just re-load the most relevant Preset back into the
Versarray™ Pro 218 Sub system from the file folder, or from the on-board DSP memory.
Note: It is strongly recommend that the EQ bands in use for the Factory Presets be left unaltered and
NOT be changed by the end user. This is the additional EQ used to generate the Factory Presets for
the Versarray™ Pro 218 Sub system, and as such, altering it will defeat to whatever extent the bands
are changed, the desired end result of the Preset’s use.
This should still leave anywhere from 10 bands of EQ to 5 bands for the Bass Boosted Presets.
Any unused EQ bands should have the
Byp
(Bypass) button clicked on (turns Orange).
CHANGING THE BANDS WITH FACTORY SETTINGS MAY VOID THE WARRANTY!
Section 17
Mute
button, a click turns the Input Page signal output OFF.
The icon turns red, and an “X” appears next to the loudspeaker symbol.
To un-mute the signal, click it again.
This action also shows up on the View Page under the Signal Flow Chart B group, where the same
icon in the signal chain shows as red when muted. As noted in that section, clicking on the icon while
on the View Page will also toggle the Mute On or Off.
Section 18
Delay
, sets the delay time of the Input Page signal for the system.
Delay Units
, Radio Buttons select the units, either
ms
(milliseconds) or
meters.
Parameter
Adj
delay increments are 1 ms (or 0.34 meters),
Fine
delay increments are approx. 0.0207 ms (or
0.007 meters), with a maximum total delay of 251 ms (or 85.3 meters).
Factory setting for this section is 0 ms.
Section 19
Gain
, sets output level of the Input Page .