ENGLISH
7
Please check with Creek Audio at [email protected] or your dealer for further information and installation. Dealer installation is recommend-
ed. Creek Audio also recommends using an external Phono pre-amp for low output Moving Coil (MC) cartridges.
DIGITAL INPUT CONNECTIONS
USB Audio
Class 2 Audio via a USB type A male, to USB type B male cable is recommended.
The Voyage i20’s DAC can operate with PCM signals up to 32-bit, 384kHz, and DSD music files up to 22.4MHz.
Coaxial 1 & 2
The maximum resolution for passing SPDIF signals is 24-bit 192 kHz. Gold plated RCA sockets connect to the DAC via galvanic
isolation transformers internally. Use a good quality 75 Ohm shielded cable for best results. Ask your dealer or Creek Audio for
further details.
Optical 1 & 2
SPDIF – TOSLINK optical socket. The maximum resolution = 24-bit 192kHz.
Optical cables are, by their nature, ground-isolated and can be purchased in various length and quality. Ask your dealer or
Creek Audio for further details.
Bluetooth
A Comet BT aptX HD Bluetooth receiver module is built-in for streaming digital signals recorded with AAC or aptX HD coding.
Range is limited by propagation through walls and other solid objects.
Screw the 11cm antenna provided into the brass coloured socket on the rear panel, bend and stand it vertically. Select the BlueT. input on the
amplifier. Go to Settings on your phone, tablet, or computer and when Creek Audio BT appears in the listing, select it, and Return to your music
application. Proceed to play your music choice. If necessary, select Creek Audio BT as the target, if it does not do so automatically. When stream-
ing music to the amplifier check if the application has a volume control. For best results set the App volume to maximum to provide the best
sound quality (lowest signal decimation). If that is not convenient, use the highest volume setting on the amp when the app it at maximum. Then
adjust the level on the App only.
Qualcomm® aptX™ HD is a product of Qualcomm Technologies Inc. and/or its subsidiaries.
PRE-AMP OUTPUT
Any analogue or digital signal input to the amplifier will be output automatically through the Pre-amp Output RCA sockets and can be connected
to another device, like a power amplifier. The Pre-amp output level must be adjusted by the volume and balance control.
GAIN
Means the amplification factor or volume level and is calculated in dBs (decibels). 0dB is maximum and -80dB is minimum. Example: +6dB is
