CREATOR CHINA
2013-09
WWW.CREATOR1997.COM
21
WiFi Conference System U
ser„s Manual
enter, and select the "Protocol" option, and then
press the "ENTER" you can enter control protocol
setting.
The system supports 4 types of control protocols,
respectively:
1) CREATOR DEF.: CREATOR conference
system standard protocol, which is used together
with the CREATOR camera tracking controller or
the third party controller.
2) PELCO-D: PELCO-D protocol; returns only to
two control codes, namely, the camera preset
spot setting and camera preset spot recall,
supports 128 preset spots, the camera address is
1.
3) PELCO-P: PELCO-P c; returns only to two
control codes, namely, the camera preset spot
setting and camera preset spot recall, supports
128 preset spots, the camera address is 1.
4) VISCA: SONY VISCA camera protocol.
Camera address is 1, the preset has been
extended to 128.
Step3, Enter the preset settings
Select the corresponding control protocol, press
"MENU" button to return to the previous menu,
select "Preset" option with the di
rection key “
”
or “
”, press "ENTER" to enter the Preset
interface.
Select "Set" with the direction key “
” or “ ”,
press "ENTER" to enter into the preset settings.
When you have selected the CREATOR
DEF protocol, Preset setting is invalid. Go to
the related description of camera tracking
controller for its related operation.
Step4, Performing preset settings
Enter the preset setting state, set the WIFI
conference controller to FIFO mode, the
maximum number of microphones is 1.
Switch the camera footage to the first unit through
the camera remote controller, and adjust the
angle or magnification, and then press the
microphone power switch to open the unit, the red
indicator of the rod is lit, and then close the
microphone, the preset setting of the unit is
completed.
Complete the preset settings of other units
according to this method.
When it comes to the preset setting of the last unit,
first adjust the camera angle and amplification,
and then press the microphone power switch to
open the unit, the red indicator of the rod is lit.
The preset setting of the unit is completed. Here
you should not close the microphone for the time
being. A
djust camera‟s panoramic picture, then
close the microphone. The preset setting of
panoramic picture is finished.
Step5, Exit preset settings
Enter the Preset interface of WIFI conference
controller, select "CALL" option, press "ENTER"
to confirm, then you are out of the preset settings,
and can achieve normal camera tracking function.